Speedline Technologies ELECTROVERT Aquastorm - Attach Machine Lock-Out Tag-Out Device

SAFETY INFORMATION
Attach Machine Lock-Out Tag-Out Device
-12 Aquastorm™ Series Options Guide Rev. 1
Attach Machine Lock-Out Tag-Out Device
Introduction Refer to the following procedure to isolate and identify all machine energy
sources. As soon as all energy sources are isolated and turned to the Off or Stop
position, notify affected personnel, and attach the lock-out tag-out device and
proceed with the required maintenance, assembly, calibration, or repair. When all
work is complete, the person who attached the lock-out tag-out device is
responsible to notify affected personnel and remove the device.
Safety To ensure personal safety and avoid equipment damage, observe the following:
Electrical Hazard
Electrical current used can kill. DO NOT TOUCH live electrical components inside
the electrical enclosure. These procedures must be performed only by an
authorized electrician, electrical engineer, or service technician familiar with
testing live voltage.
ATTENTION
If procedures must continue past the shift of the person who applied the lockout
device, ensure that an employee who is working the next shift applies their
lockout device and the previous person removes the initial lockout device.
Photograph Figure 1–4 and Figure 1–5 identify the system control pane location and layout:
Figure 1–4
Gauge Panel
Lower Control Panel
Machine Entrance End