Speedline Technologies ELECTROVERT Aquastorm - Lock-Out Tag-Out Procedures

SAFETY INFORMATION
Overview
-10 Aquastorm™ Series Options Guide Rev. 1
Section C:
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Lock-Out Tag-Out
Overview
Introduction Be sure to perform Lock-Out Tag-Out steps before beginning maintenance,
installation, or upgrade procedures. Since lock-out tag-out procedures and
policies vary from company to company, the information here is provided as a
recommended guideline. Each company must establish their own specific policies
and procedures.
Safety To minimize system down time and ensure staff safety, observe the following:
ATTENTION
If procedures must continue past the shift of the person who applied the lockout
device, ensure that an employee who is working the next shift applies their
lockout device and the previous person removes the initial lockout device.
In this Section Refer to the following lock-out tag-out procedures:
Topic See Page
Attach Facility Lock-Out Tag-Out Device 11
Attach Machine Lock-Out Tag-Out Device 12
Perform Required Task 15
Remove Lock-Out Tag Out Devices 16