CONVEYOR ENHANCEMENTS
Inlet Conveyor Extension Installation
6-80 Aquastorm™ Series Options Guide Rev. 1
6
Inlet Conveyor Extension Installation
Introduction Prior to shipment, the angle adjust inlet conveyor is removed and packed
separately in the shipping container. It is recommended that at least two (2)
people perform this installation.
Safety To ensure personal safety and avoid equipment damage observe the following:
Entanglement Hazard
All moving parts of the Aquastorm system, including pulleys, sprockets, chains,
and the conveyor represent potential hazards. Use caution and avoid having
hands or fingers caught in any moving mechanism. Long hair, jewelry, and other
parts of loose attire could be caught in moving mechanisms and cause injury.
ATTENTION
To pull the wire belt through the system, reach inside the window port of each
stage and pull the wire belt through each section.
ATTENTION
Do not to loose the Teflon
®
spacers. They must be reinstalled as the installation
progresses. It is not necessary to disassemble the idler shaft assembly.
To Next Page
Loading...