REAR EMERGENCY STOPS
Overview
3-50 Aquastorm™ Series Options Guide Rev. 1
3
Section A:
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Functional Description
Overview
Introduction Emergency stops provide a means to stop machine operation when an emergency
situation regarding the equipment, product, or personnel occurs. Each machine
comes standard with two (2) emergency stops. One (1) is located on the operator
control panel at the front entrance end of the machine. The second is located on
the sound enclosure at the front exit end of the machine.
To enhance machine safety two (2) additional emergency stops can be mounted
on the rear of the machine. One (1) mounts at the rear entrance end of the
machine and one (1) mounts at the rear exit end of the machine.
Safety To ensure personal safety and avoid equipment damage observe the following:
Electrical Hazard
Risk of Electric Shock – Turning power Off using the Emergency Stop (E-Stop)
control DOES NOT disable power to the system. To disable system power turn
Off power at the main disconnect or facility power safety disconnect.
CAUTION
Use the Emergency Stop (E-Stop) controls only in response to situations that
place operators or equipment in danger. DO NOT use E-Stop controls to routinely
shut the system down. This causes line surges and could affect machine
performance.
Diagram Figure 3–1 shows the two (2) rear emergency stops.
Figure 3–1
Machine Entrance End
Machine Exit End
To Next Page
Loading...