. . . . .
DRYER ADD-ON MODULES
Install Dryer Module
2-9317-600-00-0 Aquastorm™ Series Options Guide 14-261
Install Dryer Module
Introduction Prior to installing a single or dual dryer module, remove the exit end sound
enclosure and utility sink unit.
Safety To ensure personal safety and avoid equipment damage observe the following:
CAUTION
Heavy Objects — The single and dual dryer module units are heavy. Arrange for
three (3) or four (4) people to lift the module into position, or use a forklift or
appropriate rigging equipment to position the module for installation.
Tools and materials Use the following tools and materials to install the add-on dryer unit:
• 13 mm socket and wrench
• M8 x 40 hex head bolts
• M8 flat washers
•M8 lock washers
•M8 hex nuts
• Phillips head screwdriver
• Forklift or rigging device
• Vice clamp
• Drill and 11/32 drill bit
To Next Page
Loading...