Speedline Technologies ELECTROVERT Aquastorm - Section Q. Sump Pump; Drain Options

OPTIONS AND TECHNICAL DATA
Drain Options
2-48 Aquastorm™ Series Options Guide Rev. 1
2
Section Q:
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Sump Pump
Drain Options
Introduction At the time of manufacture, Aquastorm™ systems are configured with a single
drain system or a dual drain system. In some customer facilities drain plumbing is
not directly available to an Aquastorm™ system at the installation site. A ¾ HP or
2 HP single sump pump unit can be connected to the single drain system. Dual
drain Aquastorm systems require that two (2) sump pumps be installed.
Diagram Figure 2–24 shows the standard ¾ HP sump pump unit on the left and the 2 HP
sump pump unit on the right.
Figure 2–24