CONVEYOR ENHANCEMENTS
Board Jam Configuration
6-108 Aquastorm™ Series Options Guide Rev. 1
6
Configuration
Procedure
Configure the exit end board jam photocell as follows:
1. Press the menu key on the LCD interface keypad to access configuration
screen #1.
2. Press the page down key twice to display configuration screen #3.
3. Press the enter key to toggle through the options for board tracking and iden-
tify what features need to turn Off or remain On if a board jam is detected:
• Blower Off – Stops blower operation when product jams
• Blower On – Keeps blower operating when product jams
• Blower and IR – Keeps blower and IR heater operating when product jams
• No – Makes no change to system operation
4. Press the enter key to accept the configuration.
5. Press the Menu key to accept the changes.
6. Result: The update screen displays and the system returns to the main menu.
7. Begin system operation. For detailed information refer to the Aquastorm 200™
or Aquastorm 100™ Programming and Operation Manual.
To Next Page
Loading...