DRYER ADD-ON MODULES
Software Configuration
14-268 Aquastorm™ Series Options Guide Rev. 1
14
Configuration
Procedure
Configure the additional dryer unit as follows:
1. Press the page down key once to display configuration screen #2.
2. Press the enter key to toggle to Blower Only to indicate Dryer #3 is installed
for a single dryer addition.
3. Press the enter key to toggle to Blower Only to indicate Dryer #4 is installed.
OR
If Dryer #4 is configured with an IR heater, press the enter key to display
Blower + IR.
4. Press the enter key to accept the configuration.
5. Press the Menu key to accept the changes.
6. Result: The update screen displays and the system returns to the main menu.
To Next Page
Loading...