LIGHTED STATUS TOWER
Connect the Light Tower
5-66 Aquastorm™ Series Options Guide Rev. 1
5
Procedure Install the light tower shipped with the machine as follows:
1. Remove the tape and all packing materials securing the tower to the top of
the machine.
2. Carefully remove the bubble pack wrapping from around the status tower.
3. Position the tower and base upright on the top bulkhead.
4. Check to ensure the electrical cables are not caught under the tower base.
5. Insert the four (4) self-tapping phillips head screws into the holes in the base
of the light tower.
6. Tighten the screws securely through the light tower base and into the top
bulkhead.
7. Replace the rear system panels.
To Next Page
Loading...