See “Cut/Fill “Real-Time” Updates” on page 4-24 for more
information on how to access and use the grade indicator.
Cosmetic Changes:
• Buttons now have 3D edges.
• Menu items, surface, and equipment lists now have
descriptive bitmaps.
Miscellaneous Changes:
• File and point lists are now sorted alphabetically. Point lists
can also be sorted by clicking the column header.
• Point description fields are now drop-down lists where
previously set descriptions can be retrieved.
• Multiple selections have been added for Points, Lines,
Layers, and Surfaces.
• New layers can now be created inside the layer selection
drop-down list.
• Updated projections list, now also includes support for table
projection and multiple datums.
• Polyline segments can be viewed and edited within a list.
• The direction of a polyline can now be reversed by using the
pop-up menu. Click Linework>Reverse from the context
pop-up menu, which is activated by holding the stylus down
for one second or alternatively pressing the ALT button.
See “Main Screen” on page 1-6 for more information.
• Also, in the context menu, the length of the selected polyline
and single or multiple polyline segments can be shown. Click
Calcs ><Station>.
• Polylines can now be joined together.
• Added support for NAD83_NO_Trans. This is an added
datum option to support the use of a non-Topcon base station.
There is a difference between NAD83 and WGS84
parameters. When using a non-Topcon base station, a shift
would appear. A third-party base receiver use to be the only
option.
See “Support for non-Topcon Base Station” on page 3-22 for
To Next Page
Loading...
