TRENDnet TL2-E284 - Page 272

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
41-2
Syntax Description
number (1-65535)
Specify the alarm number.
mib-object-id (255)
The MIB OID to set alarm.
sample-interval-time
(1-2147482647)
The time interval in seconds that alarm monitors
the MIB variable.
absolute
To test the MIB variable directly.
delta
To test the change between samples of a MIB
variable.
rising-threshold
value (0-2147483647)
The threshold value to trigger alarm when the
number of sample exceeds.
rising-event-number
(1-65535)
The number of event to trigger when rising
threshold is exceeded.
falling-threshold
value (0-2147483647)
The threshold value to reset alarm when the
number of sample exceeds.
falling-event-number
(1-65535)
The number of event to trigger when falling
threshold is exceeded.
owner ownername (127)
Specify the owner of the alarm.
Command Modes
Global Configuration Mode
User Guidelines
1. RMON function must be enabled and RMON event must be configured before
configuring alarms.
2. Using no form to delete a RMON alarm on a MIB object.
Example
switch(config)# rmon alarm 1
1.3.6.1.2.1.17.7.1.3.1.1.3.141.0.0.0.0.0.22.0 10 delta
rising-threshold 15 1 falling-threshold 10 1
Command History
Version
History
1.00.001
This command was introduced
rmon event
To add an event to RMON event table.
Command
rmon event <number (1-65535)> [description <event-description
(127)>] [log] [owner <ownername (127)>] [trap <community
(127)>]
no rmon event <number (1-65535)>
Syntax Description
number (1-65535)
Specify the event number.
description
event-description (127)
Setting the description of the event.
log
Generating syslog when event is triggered.
owner ownername (127)
Specify the owner of the event.
trap community (127)
Generating a trap message when event is
triggered.