Xerox WorkCentre 6605 - Page 247

Error Troubleshooting
Xerox Internal Use Only Phaser 6600 and WorkCentre 6605
Service Manual
2-151
035 730 RS Request CS
NOT ON
In high-speed training,
modem CS does not
become ON against RS
request.
Fax Communication Error 035-
730
High speed training error.
Job canceled. Please try again.
* Caution screen with [Close]
button
Replace the
Fax Board.
035 737 CTC/EOR Resend
Over
CTC/EOR resend over. Fax Communication Error 035-
737
Continue to correct / End of
transmission resend over.
Job canceled. Please try again.
* Caution screen with [Close]
button
Replace the
Fax Board.
035 739 T5 Time Out T5 timeout Fax Communication Error 035-
739
T5 Time out for Error Correction
Mode exceeded.
Job canceled. Please try again.
* Caution screen with [Close]
button
Replace the
Fax Board.
035 740 ECM Send EOR-Q
Send
IN ECM send, send EOR-Q. Fax Communication Error 035-
740
End of retransmission ECM error
Job canceled. Please try again.
* Caution screen with [Close]
button
Replace the
Fax Board.
035 742 ECM Receive EOR-
Q Receive
IN ECM receive, receive
EOR-Q.
Fax Communication Error 035-
742
Received ECM error
Job canceled. Remote device will
try again.
* Caution screen with [Close]
button
Replace the
Fax Board.
035 746 Before Dial Dial
Ton e
Cannot detect dial tone
before dialing.
No Dial Tone 035-746
Please check that fax line is
connected and working
Job canceled.
* Caution screen with [Close]
button
Replace the
Fax Board.
WorkCentre 6605 Error Code List
Chain Link Error Error Details Control Panel Messages
FIP
location