Error Troubleshooting
Xerox Internal Use Only Phaser 6600 and WorkCentre 6605
Service Manual
2-163
093 980 IOT Y Toner Type
Error
Yellow Toner Type Error Yellow Toner Type Error 093-980
Open the Front Cover.
Then, reseat/replace the Yellow
Cartridge.
Page 2-187
093 981 IOT M Toner Type
Error
magenta Toner Type Error Magenta Toner Type Error 093-
981
Open the Front Cover.
Then, reseat/replace the Magenta
Cartridge.
Page 2-188
093 982 IOT C Toner Type
Error
Cyan Toner Type Error Cyan Toner Type Error 093-982
Open the Front Cover.
Then, reseat/replace the Cyan
Cartridge.
Page 2-188
094 417 Belt Unit Near
End Warning
Transfer Belt Unit Near
End Warning
XXXXXXXXXXXXXXXX
Transfer Unit Near End of Life
-
094 420 Belt Unit End
Warning
Transfer Belt Unit End
Warning
XXXXXXXXXXXXXXXX
Replace Transfer Unit
-
094 910 Belt Detatched Belt Detached is detected. Transfer Unit Missing
Open all covers.
Then, insert the Transfer Unit.
Reinsert the
Transfer Belt
Unit.
094 911 IOT Belt Unit Life
Over
Detect Belt Unit Life Over Transfer Unit End of Life
Open all covers.
Then, replace the Transfer Unit.
Pressing
OK will reset the counter
due to the use of a new Transfer
Unit.
When the replacement is done,
press
OK.
* Fault screen with
OK button
(Press
OK to counter reset.)
Replace the
Transfer Belt
Unit.
116 210 USB Host Error Fatal error of USB Host
driver
USB Host Error 116-210
Power Off/On the Printer.
If this failure occurs again, please
contact customer support.
Replace the
IP Board.
116 312 Encryption Key
Error
Encryption key mismatch Hard Disk Error 116-312
Power Off/On the Printer.
If this failure occurs again, please
contact customer support.
Replace the
IP Board.
WorkCentre 6605 Error Code List
Chain Link Error Error Details Control Panel Messages
FIP
location