Tool Function Operating Procedure Reference
Digital Operator Fn030
& Σ-7-Series Digital Operator Operating
Manual (Manual No.: SIEP S800001 33)
SigmaWin+ Setup - Software
Reset
Ä
Chap. 7.11.4 ‘Operating Procedure’
page 245
7.11.4 Operating Procedure
Use the following procedure to perform a software reset.
1.
Click the Servo Drive Button in the workspace of the Main Window of the Sig-
maWin+.
2. Select Software Reset in the Menu Dialog Box.
ð
The Software Reset Dialog Box will be displayed.
3. Click the Execute Button.
Fig. 184: Software Reset - Caution
Sigma-7 Series SERVOPACKs
Application Functions
Software Reset > Operating Procedure
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 245
To Next Page
Loading...
