18 Appendices
18.1 Overview
The appendix provides information on interpreting panel displays, and tables of corre-
sponding SERVOPACK and SigmaWin+ function names.
18.2 Interpreting Panel Displays
18.2.1 Overview
You can check the Servo Drive status on the panel display of the SERVOPACK.
Also, if an alarm or warning occurs, the alarm or warning number will be displayed.
18.2.2 Interpreting Status Displays
The status is displayed as described below.
Display Meaning
/TGON (Rotation Detection) Signal Display Lit if the Servomotor speed is
higher than the setting of Pn502 or Pn581 and not lit if the speed is lower
than the setting. (The default setting is 20 min
-1
or 20 mm/s.)
Base Block Display
Lit during the base block state (servo OFF). Not lit while the servo is ON.
Reference Input Display
Lit while a reference is being input.
Connected Display
Lit while there is a connection.
18.2.3 Alarm and Warning Displays
If there is an alarm or warning, the code will be displayed one character at a time, as
shown below.
Example: Alarm A.E60
Status Display
Not lit. Not lit. Not lit.Not lit.Not lit.
Fig. 388: Alarm Code Display A_E60
18.2.4 Hard Wire Base Block Active Display
If a hard wire base block (HWBB) is active, the display will change in the following order.
Sigma-7 Series SERVOPACKs
Appendices
Interpreting Panel Displays > Hard Wire Base Block Active Display
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 759
To Next Page
Loading...
