Param-
eter No.
Default
Setting
Name When Ena-
bled
Pn535 100 Program Jogging Waiting Time Immediately
Pn536 1 Program Jogging Number of Move-
ments
Immediately
Pn550 0 Analog Monitor 1 Offset Voltage Immediately
Pn551 0 Analog Monitor 2 Offset Voltage Immediately
Pn552 100 Analog Monitor 1 Magnification Immediately
Pn553 100 Analog Monitor 2 Magnification Immediately
Pn55A 1 Power Consumption Monitor Unit
Time
Immediately
Pn560 400 Residual Vibration Detection Width Immediately
Pn561 100 Overshoot Detection Level Immediately
Pn581 20 Zero Speed Level Immediately
Pn582 10 Speed Coincidence Detection
Signal Output Width
Immediately
Pn583 10 Brake Reference Output Speed
Level
Immediately
Pn584 10000 Speed Limit Level at Servo ON Immediately
Pn585 50 Program Jogging Movement Speed Immediately
Pn586 0 Motor Running Cooling Ratio Immediately
Pn587 0000h Polarity Detection Execution Selec-
tion for Absolute Linear Encoder
Immediately
Pn600 0 Regenerative Resistor Capacity Immediately
Pn601 0 Dynamic Brake Resistor Capacity Immediately
Pn603 0 Regenerative Resistance Immediately
Pn604 0 Dynamic Brake Resistance Immediately
Pn61A 0000h Overheat Protection Selections After restart
Pn61B 250 Overheat Alarm Level Immediately
Pn61C 100 Overheat Warning Level Immediately
Pn61D 0 Overheat Alarm Filter Time Immediately
* The timing for enabling changes to parameter settings depends on the parameter. Refer
to the following section for details on the enable timing.
Ä
Chap. 17.2.2 ‘List of Parameters’ page 661
Sigma-7 Series SERVOPACKs
Parameter and Object Lists
Parameter Recording Table
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 758
To Next Page
Loading...
