YASKAWA Sigma-7 SGD7S Series - 9.7 Autotuning without Host Reference; 9.7.1 Overview

17. Click the OK Button.
Fig. 236: Tuning - Software Reset Function Information
18. Click the Execute Button.
Fig. 237: Tuning - Software Reset Common for the Unit - Execute Button
ð
If the setting of the moment of inertia ratio (Pn103) was changed, the new value
will be saved and the Tuning Dialog Box will be displayed again.
This concludes the procedure to estimate the moment of inertia ratio.
9.7 Autotuning without Host Reference
9.7.1 Overview
This section describes autotuning without a host reference.
Sigma-7 Series SERVOPACKs
Tuning
Autotuning without Host Reference > Overview
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 321