*5. Always use line receivers to receive the output signals.
– You can use parameters to change the functions allocated to the /
SI0, /SI6, P-OT, N-OT, /EXT1, /EXT2, and /DEC input signals and
the /SO1, /SO2, and /SO3 output signals. Refer to the following sec-
tion for details.
Ä
Chap. 7.2 ‘I/O Signal Allocations’ page 196
– If you use a 24-V brake, install a separate power supply for the 24-
VDC power supply from other power supplies, such as the one for the
I/O signals of the CN1 connector. If the power supply is shared, the
I/O signals may malfunction.
– Default settings are given in parentheses.
5.4 Wiring the Power Supply to the SERVOPACK
5.4.1 Overview
Refer to the following manual or catalog for information on cables and peripheral devices.
& AC Servo Drives Σ-7 Series (Catalog No.: KAEP S800001 23)
& Σ-7-Series Peripheral Device Selection Manual (Manual No.: SIEP S800001 32)
5.4.2 Terminal Symbols and Terminal Names
Use the main circuit connector on the SERVOPACK to wire the main circuit power supply
and control circuit power supply to the SERVOPACK.
CAUTION!
Wire all connections correctly according to the following table and
specified reference information.
There is a risk of SERVOPACK failure or fire if incorrect wiring is per-
formed.
The SERVOPACKs have the following four types of main circuit power supply input speci-
fications.
– For the single-phase, 100 VAC power supply input specification, only
a single-phase AC power supply can be connected to the control
power supply terminals.
– For the other main circuit power supply input specifications, excluding
the single-phase, 100 VAC power supply input specification, a single-
phase AC power supply or a DC power supply can be connected to
the control power supply terminals.
Sigma-7 Series SERVOPACKs
Wiring and Connecting SERVOPACKs
Wiring the Power Supply to the SERVOPACK > Terminal Symbols and Terminal Names
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 92
To Next Page
Loading...
