ð
The newly set vibration detection level will be displayed and the value will be
saved in the SERVOPACK.
Fig. 191: Initialize Vibration Detection Level AXIS#00 - Setting Result
This concludes the procedure to initialize the vibration detection level.
7.12.5 Related Parameters
The following three items are given in the following table.
n Parameters Related to this Function
These are the parameters that are used or referenced when this function is executed.
n Changes during Function Execution
Not allowed: The parameter cannot be changed using the SigmaWin+ or other tool
while this function is being executed.
Allowed: The parameter can be changed using the SigmaWin+ or other tool while this
function is being executed.
n Automatic Changes after Function Execution
Yes: The parameter is automatically set or adjusted after execution of this function.
No: The parameter is not automatically set or adjusted after execution of this function.
Sigma-7 Series SERVOPACKs
Application Functions
Initializing the Vibration Detection Level > Related Parameters
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 251
To Next Page
Loading...
