YASKAWA Sigma-7 SGD7S Series - Page 762

SigmaWin+ SERVOPACK
Menu
Dialog
Box
Button
Function Name Fn No. Function Name
Multiturn Limit Setting Fn013 Multiturn Limit Setting after Multi-
turn Limit Disagreement Alarm
Reset Option Module Config-
uration Error
Fn014 Reset Option Module Configura-
tion Error
Initialize Vibration Detection
Level
Fn01B Initialize Vibration Detection Level
Set Origin Fn020 Set Absolute Linear Encoder
Origin
Reset Motor Type Alarm Fn021 Reset Motor Type Alarm
Software Reset Fn030 Software Reset
Polarity Detection Fn080 Polarity Detection
Tuning-less Level Setting Fn200 Tuning-less Level Setting
Easy FFT Fn206 Easy FFT
Parameters Initialize Fn005 Initializing Parameters
Write Prohibition Setting Fn010 Write Prohibition Setting
Setup Wizard – –
Tuning Autotuning without Host Ref-
erence
Fn201 Advanced Autotuning without
Reference
Autotuning with Host Refer-
ence
Fn202 Advanced Autotuning with Refer-
ence
Custom Tuning Fn203 One-Parameter Tuning
Adjust Anti-resonance Con-
trol
Fn204 Adjust Anti-resonance Control
Vibration Suppression Fn205 Vibration Suppression
Moment of Inertia Estimation – –
Monitoring Product Information Fn011 Display Servomotor Model
Fn012 Display Software Version
Fn01E Display SERVOPACK and Servo-
motor IDs
Fn01F Display Servomotor ID from
Feedback Option Module
Test Oper-
ation
Jog Fn002 Jog
Jog Program Fn004 Jog Program
Alarms Alarm Display Fn000 Display Alarm History
Fn006 Clear Alarm History
Solutions Mechanical Analysis – –
Sigma-7 Series SERVOPACKs
Appendices
Corresponding SERVOPACK and SigmaWin+ Function Names > Corresponding SERVOPACK Utility Function Names
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 762