3.3.5 Inspecting the oil level in axis-5 gearbox
Location of oil plug
The gearbox has a level plug that is located as shown in the figure.
xx1200000959
Tightening torque: 24 Nm
Required tools
NoteArticle numberEquipment, etc.
Content is defined in section Standard
toolkit on page 559.
-Standard toolkit
Required consumables
NoteArticle numberConsumables
Information about the oil is found in
Technical reference manual - Lubrica-
tion in gearboxes.
-Lubricating oil
Required documents
Document numberDocument name
3HAC042927-001Technical reference manual - Lubrication in gearboxes
Inspecting the oil level in axis-5 gearbox
Use this procedure to inspect the oil level in the gearbox.
NoteAction
Run the robot to calibration position.1
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot
working area.
2
Continues on next page
3HAC044266-001 Revision: - 113
© Copyright 2013 ABB. All rights reserved.
3 Maintenance
3.3.5 Inspecting the oil level in axis-5 gearbox
To Next Page
Loading...
