Press tool and hydraulic cylinder
The figure below shows the hydraulic cylinder mounted on the press tool.
The press tool includes two press devices that are used to different models of the
balancing device.
xx0200000174
Press blockA
Hydraulic cylinderB
Press deviceC
Bolt, press deviceD
Moving pin with markingE
Bolt (4 pcs)F
Pin, attached to the fix plateG
Required equipment
NoteArticle numberEquipment, etc.
3HAC020902-001Press tool, balancing device
To be used with the press tool.3HAC11731-1Hydraulic cylinder
To be used with the hydraulic cylinder.3HAC13086-1Hydraulic pump 80 MPa
Content is defined in section Standard
toolkit on page 559.
-Standard toolkit
Continues on next page
380 3HAC044266-001 Revision: -
© Copyright 2013 ABB. All rights reserved.
4 Repair
4.6.5 Unloading the balancing device
Continued
To Next Page
Loading...
