NoteAction
Grease: 3HAC042534-001
xx1300000832
Unscrew both screws and refill grease from
the inner hole (See figure).
3
xx1300000833
Refit the screws.4
Wipe clean from residual grease.5
DANGER
Make sure all safety requirements are met
when performing the first test run. These
are further detailed in the section DANGER
- First test run may cause injury or damage!
on page 44.
6
3HAC044266-001 Revision: - 375
© Copyright 2013 ABB. All rights reserved.
4 Repair
4.6.3 Replacing the rear bearing of the balancing device
Continued
To Next Page
Loading...
