Version 6.2 123 February 2011
SIP User's Manual 3. Web-Based Management
Parameter Description
Media Realm
[IPGroup_MediaRealm]
The Media Realm name (defined in Configuring Media Realms
on page 109) associ
ated with this IP Group. This value must be
identical (including case-sensitive) to that defined in the Media
Realm table
Note: For this parameter to take effect, a device reset is
required.
IP Profile ID
[IPGroup_ProfileId]
The IP Profile (defined in to ''Configuring IP Profile Settings'' on
page 143) th
at you want assigned to this IP Group.
The default is 0.
Gateway Parameters
Always Use Route Table
[IPGroup_AlwaysUseRouteTable]
Determines the Request-URI host name in outgoing INVITE
messages.
[0] No (default).
[1] Yes = The device uses the IP address (or domain name)
defined in the 'Outbound IP Routing Table' (see ''Configuring
the Outbound IP Routing Table'' on page 165) a
s the
Request-URI host name in outgoing INVITE messages
instead of the value entered in the 'SIP Group Name' field.
Note: This parameter is applicable only to SERVER-type IP
Groups.
Routing Mode
[IPGroup_RoutingMode]
Defines the routing mode for outgoing SIP INVITE messages.
[-1] Not Configured = The routing is according to the
selected Serving IP Group. If no Serving IP Group is
selected, the device routes the call according to the
'Outbound IP Routing Table' (see Configuring the Outbound
IP Routing Table). (Default)
[0] Routing Table = The device routes the call according to
the 'Outbound IP Routing Table'.
[1] Serving IP Group = The device sends the SIP INVITE to
the selected Serving IP Group. If no Serving IP Group is
selected, the default IP Group is used. If the Proxy server(s)
associated with the destination IP Group is not alive, the
device uses the 'Outbound IP Routing Table' (if the
parameter IsFallbackUsed is set 1, i.e., fallback enabled -
see Configuring Proxy and Registration Parameters on
page 136).
[2] Request-URI = The device sends the SIP INVITE to the
IP address according to the received SIP Request-URI host
name.
Notes:
This parameter is applicable only if the SBC or IP-to-IP
application is enabled. (The IP-to-IP application will be
supported in the next applicable release.)
This parameter is applicable only to SERVER-type IP
Groups.
SIP Re-Routing Mode
[IPGroup_SIPReRoutingMode]
Determines the routing mode after a call redirection (i.e., a 3xx
SIP response is received) or transfer (i.e., a SIP REFER
request is received).
To Next Page
Loading...
