Version 6.2 141 February 2011
SIP User's Manual 3. Web-Based Management
2. From the 'Coder Group ID' drop-down list, select a Coder Group ID.
3. From the 'Coder Name' drop-down list, select the first coder for the Coder Group.
4. From the 'Packetization Time' drop-down list, select the packetization time (in msec)
for the coder. The packetization time determines how many coder payloads are
combined into a single RTP packet.
5. From the 'Rate' drop-down list, select the bit rate (in kbps) for the coder you selected.
6. In the 'Payload Type' field, if the payload type (i.e., format of the RTP payload) for the
coder you selected is dynamic, enter a value from 0 to 120 (payload types of 'well-
known' coders cannot be modified).
7. From the 'Silence Suppression' drop-down list, enable or disable the silence
suppression option for the coder you selected.
8. Repeat steps 3 through 7 for the next coders (optional).
9. Repeat steps 2 through 8 for the next coder group (optional).
10. Click the Submit button to save your changes.
11. To save the changes to flash memory, see ''Saving Configuration'' on page 336.
3.3.2.10.3 Configuring Tel Profile
The 'Tel Profile Settings' page allows you to define up to nine Tel Profiles. You can assign
these Tel Profiles to the device's channels in the Hunt Group Table (see Configuring the
Hunt Group Table on page 146)), a
nd thereby, apply different behaviors to different
channels.
Note: You can also configure Tel Profiles using the ini file table parameter TelProfile
(see SIP Configuration Parameters).
To Next Page
Loading...
