WATERLEAKS 9I–5
DAEWOO M-150 BL2
REPAIR INSTRUCTIONS
ON–VEHICLE SERVICE
D109A501
D109A502
WATERLEAK REPAIR
Some waterleaks around the glass can be repaired with-
out removing the glass.
Important: This type of repair may be used only for ure-
thane–installed glass.
1 Remove the reveal molding in the area of the leak. It
may be necessary to remove the garnish molding or
the trim strip lace in order to locate the leak.
2. While spraying water over leak area, carefully push
the glass outward in order to determine the size of the
leak.
3. Mark the location of the leak.
4. Use water to clean any dirt frame the area. Dry the
area with an air hose.
D109A503
5. Using a sharp knife, trim off the uneven edges of the
adhesive caulking material around the leak for a dis-
tance of 75 to 100 mm (3 to 4 inches) on both side of
the leak.
To Next Page
Loading...
