Daewoo MATIZ - Compressor; Receiver-Dryer Bracket

7B–20 MANUAL CONTROL HEATING, VENTILATION, AND AIR CONDITIONING SYSTEM
DAEWOO M-150 BL2
D108B507
RECEIVER DRYER BRACKET
Removal Procedure
1. Remove the front bumper fascia. Refer to Section
9O, Bumpers and Fascias.
2. Remove the receiver dryer bracket.
D Remove the receiver dryer bracket bolt (1).
D Remove the receiver dryer bracket–to–body bolts
(2).
D18B508B
Installation Procedure
1. Install the receiver dry bracket with the bolts.
Tighten
D Tighten the receiver dryer bracket–to–body bolts
to 5 NSm (44 lb-in) (1).
D Tighten the receiver dryer bracket bolt to 5 NSm
(44 lb-in) (2).
2. Install the front bumper fascia. Refer to Section 9O,
Bumpers and Fascias.
D108B509
D18B510A
COMPRESSOR
Removal Procedure
1. Remove the receiver dryer. Refer to “Receiver Dryer
and Dual Cut Switch” in this section.
2. Remove the A/C belt. Refer to Section 6B, Power
Steering Pump.
3. Remove the compressor.
D Discharge and recover the refrigerant. Refer to
“Discharging, Adding Oil, Evacuating, and Charg-
ing Provedures for A/C System” in this section.
D Remove the bolt securing the low pressure pipe
line to the compressor (1).
D Remove the bolt securing the high pressure pipe
line to the compressor (2).
D Disconnect the electrical connector (3).
D Remove the upper bolt mounting the compressor–
to–bracket (4).
D Remove the lower bolts mounting the compres-
sor–to–bracket (5).