REMOTE KEYLESS ENTRY AND ANTI-THEFT SYSTEM 9T–5
DAEWOO M-150 BL2
PASSWORD PROGRAMMING
If a transmitter is lost or damaged, the control module/
receiver must be re-programmed to communicate with a
new transmitter. The passwords recorded in the control
module/receiver should not be deleted when power is off
in the control module/receiver.
Each control module/receiver should be able to record
five passwords. The following method is used to record
new passwords in the control module/receiver:
1. Connect the scan tool to the data link connector
(DLC) connector.
2. Send the programming mode message to the control
module/receiver.
3. Press any button of the transmitter to generate a data
code including a password which will be recorded by
the control module/receiver. The control module/re-
ceiver sends a response message to the scan tool to
indicate that the first password has been recorded.
4. Press any button of the transmitter three more times
until the control module/receiver has responded that
the third, fourth, and fifth passwords have been re-
corded.
5. Disconnect the scan tool.
The control module/receiver leaves the programming
mode automatically and switches to the normal operat-
ing mode when either of the following conditions occurs:
D The scan tool is disconnected from the DLC.
D Five passwords are recorded in the control module/
receiver.
To Next Page
Loading...
