ENGINE CONTROLS 1F–311
DAEWOO M-150 BL2
MAA1F450
2. Remove the MAP sensor.
D Remove the bolts (1).
D Remove the MAP sensor with bracket (2).
MAA1F460
Installatin Procedure
1. Install in the reverse order of removal.
D Inspect the MAP sensor vacuum hose for the tear
and damages.
2. Install the MAP sensor with the bolts and nuts.
Tighten
Tighten the MAP sensor bolts/nuts to 8–12 NSm
(71–106 lb-in).
Tighten the MAP sensor bracket bolt to 8–12 NSm
(71–106 lb-in).
D102F537
THROTTLE BODY
Removal Procedure
1. Remove the air cleaner/resonator assembly and air
intake tube. Refer to Section 1B, SOHC Engine Me-
chanical.
2. Drain the engine coolant. Refer to Section 1D, Engine
Cooling.
D102F538
3. Disconnect the throttle cable, the throttle position
sensor and the idle air control valve connectors.
D Open the throttle valve (1).
D Disconnect the throttle cable (2).
D Disconnect the idle air control valve connector (3).
D Disconnect the throttle position sensor connector
(4).
To Next Page
Loading...
