Daewoo MATIZ - Steering Column

STEERING WHEEL AND COLUMN 6E–11
DAEWOO M-150 BL2
D105A515
STEERING COLUMN
(Left–Hand Drive Shown, Right–Hand
Drive Similar)
Removal Procedure
1. Remove the steering wheel. Refer to “Steering Wheel”
in this section.
Caution: Disconnect the negative battery cable and
let the vehicle sit for 1 minute to deactivate the air-
bag (For vehicle with SIR)
2. Remove the turn signal switch and wiper switch. Re-
fer to “Turn Signal Switch and Lever/Wiper Switch
and Lever in this section.
3. Remove the switch housing. Refer to “Switch Hous-
ing” in this section.
D105A516
4. Remove the ignition switch. Refer to “Ignition Switch”
in this section.
5. Remove the ignition lock cylinder. Refer to “Ignition
Lock Cylinder” in this section.
6. Remove the steering column.
D Match–mark on the intermediate shaft and the
steering column shaft (1).
D Remove the intermediate shaft upper pinch bolt
(2).
D Remove the steering column lower nuts (3).
D Remove the steering column upper nuts (4).
D15A517B
D15A518B
Installation Procedure
Important: Align the match–mark on the intermediate
shaft and the steering column shaft.
1. Install the steering column.
D Install the intermediate shaft upper pinch bolt (1).
Tighten
Tighten the pinch bolt to 21–29 NSm (16–22 lb-ft).
D Install the steering column lower nuts (2).
Tighten
Tighten the nuts to 15–20 NSm (11–15 lb-ft).
D Install the steering column upper nuts (3).
Tighten
Tighten the nuts to 15–20 NSm (11–15 lb-ft).
2. Install the ignition lock cylinder. Refer to “Ignition Lock
Cylinder” in this section.
3. Install the ignition switch. Refer to “Ignition Switch” in
this section.
4. Install the switch housing. Refer to “Switch Housing”
in this section.
5. Install the turn signal switch and wiper switch. Refer
to “Turn Signal Switch and Lever/Wiper Switch and
Lever” in this section.
6. Install the steering wheel. Refer to “Steering Wheel”
in this section.