Daewoo MATIZ - Turn Signal Lamps and Hazard Lamps

9B–4 LIGHTING SYSTEMS
DAEWOO M-150 BL2
TURN SIGNAL LAMPS AND HAZARD LAMPS
Condition Probable Cause Correction
Turn Signal Lamps and Hazard
Lamps Do Not Work.
D The open circuit or a short circuit
between the power supply circuit
and the fuse Ef2.
D Repair or Replace the wiring
harness.
D Fuse Ef2 is blown. D Replace the fuse Ef2.
D The open circuit or a short circuit
between the fuse Ef2 and the fuse
F12.
D Repair of Replace the wiring
harness.
D Fuse F12 is blown. D Replace the fuse F12.
D The open circuit or a short circuit
between the fuse F12 and the
terminal 8 of the hazard lamp
switch connector.
D Repair or Replace the wiring
harness.
D Faulty hazard lamp switch. D Replace the hazard lamp switch.
D The open circuit or a short circuit
between the terminal 7 of the
hazard lamp switch connector and
the terminal 49 of the turn signal
lamp relay.
D Repair or Replace the wiring
harness.
D The open circuit or a short circuit
between the terminal 49a of the
turn signal lamp relay and the
terminal 9 of the hazard lamp
switch connector.
D Repair or Replace the wiring
harness.
D Faulty turn signal lamp relay. D Replace the turn signal lamp relay.
D The open circuit or a short circuit
between the terminal 49a of the
turn signal lamp relay and the
terminal 2 of the turn signal lamp
switch connector.
D Faulty turn signal lamp switch. D Replace the turn signal lamp
switch.
D The open circuit or a short circuit
between the terminal 1,3 of the
turn signal switch connector and
the terminal 2,5 of each turn signal
lamp connectors.
D Repair or Replace the wiring
harness.
D Turn signal lamp bulb is blown. D Replace the turn signal lamp bulb.
D The open grounds (G101, G102,
G401, G402) circuits.
D Repair or Replace the open
ground circuit.
Hazard Lamps Do Not Operate,
Turn Signals Are OK.
D The open circuit or a short circuit
between the terminal 49a of the
turn signal lamp relay and the
terminal 9 of the hazard lamp
switch connector.
D Repair or Replace the open
circuit.
D The open circuit or a short circuit
between the terminals 5,6 of the
hazard lamp switch connector and
the terminals 2,5 of the turn signal
lamp connectors.
D Repair or Replace the wiring
harness.