5B–36 FIVE-SPEED MANUAL TRANSAXLE
DAEWOO M-150 BL2
D13B744A
24. Install the backup light switch and the speedometer
driven gear assembly.
D Install the backup light switch (1).
Tighten
Tighten the nut to 15–18 NSm (11–13 lb-ft) (a).
D Install the speedometer driven gear assembly
(2).
Tighten
Tighten the bolt to 4–7 NSm (35–62 lb-in) (b).
D Install the hydraulic pump assembly (If equipped
with auto clutch). Refer to Section 5D, Auto
Clutch.
D13B7452
25. Install the transaxle mount.
D Install the mount (1).
Tighten
D Tighten the bolts to 55–65 NSm (41–48 lb-ft) (a).
D Tighten the nut to 55–65 NSm (41–48 lb-ft) (b).
D13B701A
26. Install the related clutch parts. Refer to Section 5C,
Clutch.
27. Remove the transaxle assembly from transaxle
stand.
D Remove the transaxle assembly using the trans-
axle fixture DW220–010A.
28. Install the transaxle assembly. Refer to “Manual
Transaxle Assembly” in this section.
D103B746
INPUT SHAFT
Tools Required
DW09921–57810 Gear, Bearing Remover
DW09925–98221 Gear, Bearing Installer
DW09940–53111 Gear, Bearing Installer
Disassembly Procedure
1. Remove the gear unit. Refer to “Gear Unit” in this
section.
2. Remove the input shaft right side bearing.
D Position the bearing to the gear, bearing remover
DW09921–57810.
D Remove the bearing by pressing (1).
To Next Page
Loading...
