Daewoo MATIZ - Front Bumper Impact Bar

BUMPERS AND FASCIAS 9O–5
DAEWOO M-150 BL2
D19C504A
7. Lower the vehicle.
8 Remove the front bumper spacer from the bumper.
Refer to Section 9M, Exterior Trim.
9. Remove the front bumper fascia.
D Remove the bolts (1).
D Remove the clips (2).
D Remove the front bumper fascia (3).
10 Remove the front fog lamps. Refer to Section 9B,
Lighting Systems.
D19C505A
Installation Procedure
Notice: Dissimilar metals in direct contact with each
other may corrode rapidly. Make sure to use the correct
fasteners to prevent premature corrosion.
1. Install the front fog lamps. Refer to Section 9B,
Lighting Systems.
2. Install the bumper fascia.
3. Install the clips on the top of the fascia.
a. Fascia upper clip.
4. Install the bolts on the top of the fascia.
b. Fascia upper bolt.
5. Install the front bumper spacer. Refer to Section 9M,
Exterior Trim.
D109C506
6. Raise and suitably support the vehicle.
7. Install the clips under the fascia.
c. Fascia lower clip.
8. Install the bolts on the both side of the fascia.
9. Install the front wheelhouse splash shields with the
clips and the bolts.
10. Install the front wheels.
11. Lower the vehicle.
12. Connect the negative battery cable.
D19C507A
FRONT BUMPER IMPACT BAR
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the front bumper fascia. Refer to “Front
Bumper Fascia” in this section.
3. Remove the front wiring harness retaining clip from
the impact bar.