1E–14 ENGINE ELECTRICAL
DAEWOO M-150 BL2
REPAIR INSTRUCTIONS
ON–VEHICLE SERVICE
D12E5011
STARTER
Removal Procedure
1. Disconnect the negative battery cable.
2. Disconnect the electrical connector and clip around
the starter.
D Remove the engine oil temperature sensor to dis-
connect the harness connector (1).
D Remove the starter solenoid nut to disconnect the
electrical cable (2).
D Remove the harness clip bolt to disconnect the
harness clip (3).
D Remove the ground bolt (4).
D102E502
3. Remove the starter assembly.
D Remove the starter mounting bolts (1).
D Remove the starter assembly (2).
D12E5031
Installation procedure
1. Install in the reverse order of removal.
2. Install the starter mounting bolts and starter solenoid
nut.
Tighten
D Tighten the starter mounting bolts to 55–65 NSm
(41–48 lb-ft) (a).
D Tighten the starter solenoid nut to 9–12 NSm
(80–106 lb-in) (b).
D Tighten the harness clip bolt to 9–12 NSm (80–106
lb-in) (c).
D Tighten the ground bolt to 35–41 NSm (26–30 lb-ft)
(d).
To Next Page
Loading...
