1F–92 ENGINE CONTROLS
DAEWOO M-150 BL2
DTC P0133 – Oxygen Sensor No Activity (Cont’d)
Step Action Value(s) Yes No
11
Replace the O
2
sensor.
Is the repair complete?
–
Go to Step 12
–
12
1. Clear any DTCs from the ECM
2. Perform the diagnostic system check
Is the repair complete
–
Go to Step 13
–
13
Check if any additional DTCs are set.
Are any DTCs displaced that have not been
diagnosed?
–
Go to applicable
DTC table System OK