1F–308 ENGINE CONTROLS
DAEWOO M-150 BL2
D102F516
6. Remove the fuel tank.
D Lower slowly the jack to remove the fuel tank easi-
ly (1).
D Disconnect the canister hose which is connected
to the roll over valve from the fuel tank removed
(2).
D Inspect the fuel tank for clacks, damages, and con-
taminations.
D Inspect the fuel lines for cracks and damages.
D12F517A
Installation Procedure
1. Install in the reverse order of removal.
D After the installation is complete, start the engine
to prevent the vapor lock and check the hoses for
leaks.
2. Install the fuel tank strap bolts.
Tighten
Tighten the fuel tank strap bolts to 18–22 NSm (13–16
lb-ft).
D102F519
D102F518
FUEL RAIL AND INJECTORS
Removal Procedure
Caution: The fuel system is under pressure. To
avoid fuel spillage and the risk of personal injury or
fire, it is necessary to relieve the fuel system pres-
sure before disconnecting the fuel lines.
1. Relieve the fuel system pressure.
Refer to “Fuel Pump” in this section.
2. Remove the canister from the engine room. Refer to
“Evaporative Emission Canister” in this section.
3. Disconnect the fuel inlet line (1).
4. Disconnect the fuel injector harness connectors (2).
To Next Page
Loading...
