EasyManua.ls Logo

Daewoo MATIZ - Page 433

Daewoo MATIZ
1184 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2A2 SUSPENSION DIAGNOSIS
DAEWOO M-150 BL2
ÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁ
Condition
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
Probable Cause
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
Correction
Car Lead/Pull
D Mismatched or uneven tires. D Replace the tires.
D A broken or a sagging coil spring. D Replace the coil spring.
D A improperly radial tire lateral force. D Check the wheel alignment.
D Switch the tire and wheel assemblies.
D Replace the tires as needed.
D The frontwheel alignment is
outofalign.
D Align the front wheels.
D Offcenter steering gear. D Reseat the pinion valve assembly.
D Replace the pinion valve assembly as
needed.
D Frontbrake dragging. D Adjust the front brakes.
Abnormal or Excessive
Tire Wear
D The frontwheel and rearwheel
alignment is outofalign.
D Align the front and the rear wheels.
D Excessive toe. D Adjust the toe.
D A broken or a sagging coil spring. D Replace the coil spring.
D Outofbalance tires. D Balance the tires.
D Worn strut dampeners. D Replace the strut dampeners.
D A failure to rotate tires. D Rotate the tires.
D Replace the tires as needed.
D Overloaded vehicle. D Maintain the proper load weight.
D Low tire inflation. D Inflate the tires to the proper pressure.
Scuffed Tires
D Incorrect toe. D Adjust the toe.
D A twisted or a bent suspension arm. D Replace the suspension arm.
Wheel Tramp
D An outofbalance tire or wheel. D Balance the tire or the wheel.
D Improper strut dampener action. D Replace the strut dampeners.
Shimmy, Shake, or
D An outofbalance tire or wheel. D Balance the tire or the wheel.
Vibration
D Excessive wheel hub runout. D Measure the hub flange runout.
D Replace the hub as needed.
D Excessive brake drum or brake rotor
imbalance.
D Adjust the brakes.
D Replace the brake rotor or the brake
drum as needed.
D Worn tie rod ends. D Replace the tie rod ends.
D Wheel trim imbalance. D Balance the wheel.
D A worn ball joint. D Replace the control arm and ball joint
assembly.
D Excessive wheel runout. D Measure the wheel runout.
D Replace the wheel as needed.
D Excessive loaded radial runout on the
tire and wheel assembly.
D Matchmount the tire and wheel
assembly.

Table of Contents

Related product manuals