Chapter 4
| System Management Commands
Switch Clustering
– 193 –
Command Mode
Global Configuration
Command Usage
◆ The maximum number of cluster Members is 36.
◆ The maximum number of cluster Candidates is 100.
Example
Console(config)#cluster member mac-address 00-12-34-56-78-9a id 5
Console(config)#
rcommand This command provides access to a cluster Member CLI for configuration.
Syntax
rcommand id member-id
member-id - The ID number of the Member switch. (Range: 1-36)
Command Mode
Privileged Exec
Command Usage
◆ This command only operates through a Telnet connection to the Commander
switch. Managing cluster Members using the local console CLI on the
Commander is not supported.
◆ There is no need to enter the username and password for access to the Member
switch CLI.
Example
Console#rcommand id 1
CLI session with the ECS4620-28T is opened.
To end the CLI session, enter [Exit].
Vty-0#
To Next Page
Loading...
