Chapter 14
| Multicast Filtering
Layer 2 IGMP (Snooping and Query for IPv4)
– 547 –
Show Static Multicast Router
◆ VLAN – Selects the VLAN for which to display any configured static multicast
routers.
◆ Interface – Shows the interface to which the specified static multicast routers
are attached.
Show Current Multicast Router
◆ VLAN – Selects the VLAN for which to display any currently active multicast
routers.
◆ Interface – Shows the interface to which an active multicast router is attached.
◆ Type – Shows if this entry is static or dynamic.
◆ Expire – Time until this dynamic entry expires.
Web Interface
To specify a static interface attached to a multicast router:
1. Click Multicast, IGMP Snooping, Multicast Router.
2. Select Add Static Multicast Router from the Action list.
3. Select the VLAN which will forward all the corresponding multicast traffic, and
select the port or trunk attached to the multicast router.
4. Click Apply.
Figure 338: Configuring a Static Interface for a Multicast Router
To show the static interfaces attached to a multicast router:
1. Click Multicast, IGMP Snooping, Multicast Router.
2. Select Show Static Multicast Router from the Action list.
3. Select the VLAN for which to display this information.
To Next Page
Loading...
