Chapter 4
| System Management Commands
SMTP Alerts
– 169 –
SMTP Alerts
These commands configure SMTP event handling, and forwarding of alert
messages to the specified SMTP servers and email recipients.
logging sendmail This command enables SMTP event handling. Use the no form to disable this
function.
Syntax
[no] logging sendmail
Default Setting
Enabled
Command Mode
Global Configuration
Example
Console(config)#logging sendmail
Console(config)#
logging sendmail host This command specifies SMTP servers that will be sent alert messages. Use the no
form to remove an SMTP server.
Syntax
[no] logging sendmail host ip-address
ip-address - IPv4 or IPv6 address of an SMTP server that will be sent alert
messages for event handling.
Table 23: Event Logging Commands
Command Function Mode
logging sendmail Enables SMTP event handling GC
logging sendmail host SMTP servers to receive alert messages GC
logging sendmail level Severity threshold used to trigger alert messages GC
logging sendmail
destination-email
Email recipients of alert messages GC
logging sendmail source-
email
Email address used for “From” field of alert messages GC
show logging sendmail Displays SMTP event handler settings NE, PE
To Next Page
Loading...
