Chapter 14
| Multicast Filtering
Filtering and Throttling IGMP Groups
– 563 –
Parameters
These parameters are displayed:
Add
◆ Profile ID – Creates an IGMP profile. (Range: 1-4294967295)
◆ Access Mode – Sets the access mode of the profile; either permit or deny.
(Default: Deny)
When the access mode is set to permit, IGMP join reports are processed when a
multicast group falls within the controlled range. When the access mode is set
to deny, IGMP join reports are only processed when the multicast group is not
in the controlled range.
Add Multicast Group Range
◆ Profile ID – Selects an IGMP profile to configure.
◆ Start Multicast IP Address – Specifies the starting address of a range of
multicast groups.
◆ End Multicast IP Address – Specifies the ending address of a range of
multicast groups.
Web Interface
To create an IGMP filter profile and set its access mode:
1. Click Multicast, IGMP Snooping, Filter.
2. Select Configure Profile from the Step list.
3. Select Add from the Action list.
4. Enter the number for a profile, and set its access mode.
5. Click Apply.
Figure 351: Creating an IGMP Filtering Profile
To Next Page
Loading...
Need help?
General