Chapter 5
| VLAN Configuration
IEEE 802.1Q VLANs
– 173 –
To configure static members by interface range:
1. Click VLAN, Static.
2. Select Edit Member by Interface Range from the Action list.
3. Set the Interface type to display as Port or Trunk.
4. Enter an interface range.
5. Modify the VLAN parameters as required. Remember that the PVID, acceptable
frame type, and ingress filtering parameters for each interface within the
specified range must be configured on either the Edit Member by VLAN or Edit
Member by Interface page.
6. Click Apply.
Figure 76: Configuring Static VLAN Members by Interface Range
Configuring Dynamic
VLAN Registration
Use the VLAN > Dynamic page to enable GVRP globally on the switch, or to enable
GVRP and adjust the protocol timers per interface.
Parameters
These parameters are displayed:
Configure General
◆ GVRP Status – GVRP defines a way for switches to exchange VLAN information
in order to register VLAN members on ports across the network. VLANs are
dynamically configured based on join messages issued by host devices and
propagated throughout the network. GVRP must be enabled to permit
automatic VLAN registration, and to support VLANs which extend beyond the
local switch. (Default: Disabled)
To Next Page
Loading...
Need help?
General