Chapter 14
| Multicast Filtering
Layer 2 IGMP (Snooping and Query for IPv4)
– 558 –
Displaying IGMP
Snooping Statistics
Use the Multicast > IGMP Snooping > Statistics pages to display IGMP snooping
protocol-related statistics for the specified interface.
Parameters
These parameters are displayed:
◆ VLAN – VLAN identifier. (Range: 1-4094)
◆ Port – Port identifier. (Range: 1-28/52)
◆ Trunk – Trunk identifier. (Range: 1-16)
Query Statistics
◆ Other Querier – IP address of remote querier on this interface.
◆ Other Querier Expire – Time after which remote querier is assumed to have
expired.
◆ Other Querier Uptime – Time remote querier has been up.
◆ Self Querier – IP address of local querier on this interface.
◆ Self Querier Expire – Time after which local querier is assumed to have
expired.
◆ Self Querier Uptime – Time local querier has been up.
◆ General Query Received – The number of general queries received on this
interface.
◆ General Query Sent – The number of general queries sent from this interface.
◆ Specific Query Received – The number of specific queries received on this
interface.
◆ Specific Query Sent – The number of specific queries sent from this interface.
◆ Warn Rate Limit – The rate at which received query messages of the wrong
version type cause the Vx warning count to increment. Note that “0 sec” means
that the Vx warning count is incremented for each wrong message version
received.
◆ V1 Warning Count – The number of times the query version received
(Version 1) does not match the version configured for this interface.
◆ V2 Warning Count – The number of times the query version received
(Version 2) does not match the version configured for this interface.
To Next Page
Loading...
Need help?
General