– 21 –
Figures
Figure 1: Home Page 56
Figure 2: Front Panel Indicators 58
Figure 3: System Information 84
Figure 4: General Switch Information 86
Figure 5: Configuring Support for Jumbo Frames 87
Figure 6: Displaying Bridge Extension Configuration 88
Figure 7: Copy Firmware 90
Figure 8: Saving the Running Configuration 92
Figure 9: Setting Start-Up Files 92
Figure 10: Displaying System Files 93
Figure 11: Configuring Automatic Code Upgrade 97
Figure 12: Manually Setting the System Clock 98
Figure 13: Setting the Polling Interval for SNTP 99
Figure 14: Configuring NTP 100
Figure 15: Specifying SNTP Time Servers 101
Figure 16: Adding an NTP Time Server 102
Figure 17: Showing the NTP Time Server List 102
Figure 18: Adding an NTP Authentication Key 103
Figure 19: Showing the NTP Authentication Key List 104
Figure 20: Setting the Time Zone 105
Figure 21: Console Port Settings 106
Figure 22: Telnet Connection Settings 108
Figure 23: Displaying CPU Utilization 109
Figure 24: Displaying Memory Utilization 109
Figure 25: Setting the Stack Master 111
Figure 26: Enabling Stacking on 10G Ports 112
Figure 27: Renumbering the Stack 112
Figure 28: Restarting the Switch (Immediately) 115
Figure 29: Restarting the Switch (In) 115
To Next Page
Loading...
Need help?
General