Edge-Core ECS4620-28T - Page 28

Figures
– 22 –
Figure 30: Restarting the Switch (At) 116
Figure 31: Restarting the Switch (Regularly) 116
Figure 32: Configuring Connections by Port List 120
Figure 33: Configuring Connections by Port Range 121
Figure 34: Displaying Port Information 122
Figure 35: Configuring Local Port Mirroring 122
Figure 36: Configuring Local Port Mirroring 123
Figure 37: Displaying Local Port Mirror Sessions 124
Figure 38: Configuring Remote Port Mirroring 124
Figure 39: Configuring Remote Port Mirroring (Source) 127
Figure 40: Configuring Remote Port Mirroring (Intermediate) 128
Figure 41: Configuring Remote Port Mirroring (Destination) 128
Figure 42: Showing Port Statistics (Table) 131
Figure 43: Showing Port Statistics (Chart) 132
Figure 44: Displaying Transceiver Data 134
Figure 45: Configuring Transceiver Thresholds 136
Figure 46: Performing Cable Tests 138
Figure 47: Configuring Static Trunks 139
Figure 48: Creating Static Trunks 140
Figure 49: Adding Static Trunks Members 141
Figure 50: Configuring Connection Parameters for a Static Trunk 141
Figure 51: Showing Information for Static Trunks 142
Figure 52: Configuring Dynamic Trunks 142
Figure 53: Configuring the LACP Aggregator Admin Key 145
Figure 54: Enabling LACP on a Port 146
Figure 55: Configuring LACP Parameters on a Port 146
Figure 56: Showing Members of a Dynamic Trunk 147
Figure 57: Configuring Connection Settings for a Dynamic Trunk 147
Figure 58: Showing Connection Parameters for Dynamic Trunks 148
Figure 59: Displaying LACP Port Counters 149
Figure 60: Displaying LACP Port Internal Information 150
Figure 61: Displaying LACP Port Remote Information 152
Figure 62: Configuring Load Balancing 153
Figure 63: Enabling Power Savings 155
Figure 64: Enabling Traffic Segmentation 157