ā 1157 ā
51 Multicast Routing Commands
Multicast routers can use various kinds of multicast routing protocols to deliver IP
multicast packets across different subnetworks. This router supports Protocol
Independent Multicasting (PIM). (Note that IGMP will be enabled for any interface
that is using multicast routing.)
General Multicast Routing
This section describes commands used to configure multicast routing globally on
the switch.
IPv4 Commands
ip multicast-routing This command enables IPv4 multicast routing. Use the no form to disable IP
multicast routing.
Syntax
[no] ip multicast-routing
Table 30: Multicast Routing Commands
Command Group Function
General Multicast Routing Enables IP multicast routing globally; also displays the IP multicast
routing table created from static and dynamic routing information
Static Multicast Routing Configures static multicast router ports
PIM Multicast Routing Configures global and interface settings for PIM-DM and PIM-SM
Table 31: General Multicast Routing Commands
Command Function Mode
IPv4 Commands
ip multicast-routing Enables IPv4 multicast routing GC
show ip mroute Shows the IPv4 multicast routing table PE
IPv6 Commands
ipv6 multicast-routing Enables IPv6 multicast routing GC
show ipv6 mroute Shows the IPv6 multicast routing table PE
To Next Page
Loading...
