Chapter 19
| Unicast Routing
Configuring the Routing Information Protocol
– 703 –
◆ Clear Route By Network – Clears a specific route based on its IP address and
prefix length.
â–
Network IP Address – Deletes all related entries for the specified network
address.
â–
Prefix Length – A decimal value indicating how many contiguous bits
(from the left) of the address comprise the network portion of the address.
Web Interface
To clear entries from the routing table RIP:
1. Click Routing Protocol, RIP, General.
2. Select Clear Route from the Action list.
3. When clearing routes by type, select the required type from the drop-down list.
When clearing routes by network, enter a valid network address and prefix
length.
4. Click Apply.
Figure 466: Clearing Entries from the Routing Table
Specifying
Network Interfaces
Use the Routing Protocol > RIP > Network (Add) page to specify the network
interfaces that will be included in the RIP routing process.
Command Usage
â—† RIP only sends and receives updates on specified interfaces. If a network is not
specified, the interfaces in that network will not be advertised in any RIP
updates.
â—† No networks are specified by default.
To Next Page
Loading...
Need help?
General