Chapter 12
| Security Measures
Filtering IP Addresses for Management Access
– 350 –
■
Telnet – Configures IP address(es) for the Telnet group.
■
All – Configures IP address(es) for all groups.
◆ Start IP Address – A single IP address, or the starting address of a range.
◆ End IP Address – The end address of a range.
Web Interface
To create a list of IP addresses authorized for management access:
1. Click Security, IP Filter.
2. Select Add from the Action list.
3. Select the management interface to filter (Web, SNMP, Telnet, All).
4. Enter the IP addresses or range of addresses that are allowed management
access to an interface.
5. Click Apply
Figure 215: Creating an IP Address Filter for Management Access
To Next Page
Loading...
