Chapter 19
| Unicast Routing
Configuring the Open Shortest Path First Protocol (Version 2)
– 723 –
Web Interface
To configure general settings for OSPF:
1. Click Routing Protocol, OSPF, System.
2. Select Configure from the Action list.
3. Select a Process ID, and then specify the Router ID and other global attributes
as required. For example, by setting the Auto Cost to 10000, the cost of using an
interface is set to 10 for Gigabit ports, and 1 for 10 Gigabit ports.
4. Click Apply
Figure 488: Configure General Settings for OSPF
Displaying
Administrative
Settings and Statistics
Use the Routing Protocol > OSPF > System (Show) page to display general
administrative settings and statistics for OSPF.
Parameters
These parameters are displayed:
Table 43: OSPF System Information
Parameter Description
Router ID Type Indicates if the router ID was manually configured or automatically
generated by the system.
Rx LSAs The number of link-state advertisements that have been received.
To Next Page
Loading...
Need help?
General