Chapter 4
| Interface Configuration
Trunk Configuration
– 147 –
4. Select a Trunk.
Figure 56: Showing Members of a Dynamic Trunk
To configure connection parameters for a dynamic trunk:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Trunk from the Step list.
3. Select Configure from the Action list.
4. Modify the required interface settings. (See “Configuring by Port List” on
page 118 for a description of the interface settings.)
5. Click Apply.
Figure 57: Configuring Connection Settings for a Dynamic Trunk
To Next Page
Loading...
Need help?
General